Summer Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: exc65

examout.co

Which of the following is NOT supported in Alarm Settings?

A.

Raise alarm when network interface duplex errors are detected

B.

Raise alarm when network interface link errors are detected

C.

Raise alarm when the number of optimized connections exceeds user specified limit

D.

Raise alarm if a software version mismatch is detected in the network

E.

Raise alarm when asymmetric routes are detected

When troubleshooting a datastore wrapping alarm with 1 day wrapping notification configured, which of the following should be examined? (Select 2)

A.

If the unit was mis-sized

B.

If stream based encrypted traffic is being sent across the link as optimized

C.

If your fixed-target rules are pointing to the correct Steelhead appliance

D.

If Connection Forwarding was properly configured

If a file is not optimized for more than one user at a time, this indicates:

A.

Steelhead appliance has entered admission control

B.

Steelhead appliance is configured with the incorrect speed or duplex on the Primary interface

C.

Steelhead appliance is configured with the incorrect speed or duplex on of the in-path interfaces

D.

Steelhead appliance is not able to acquire a “File Hold Key (FHK)”

E.

Steelhead appliance is not able to acquire an “Opportunistic Lock (oplock)”

F.

Steelhead appliance is not able to acquire a “Double Link (doulink)”

In an existing deployment, all connections appear to be unoptimized. The Current Connections page lists the connections as pass-through.

The logs indicate admission control “Jan 19 18:44:56 client sport[343]: [admission_control.WARN] Pausing intercept.” What are some possible ways to alleviate the problem? (Select 2)

A.

Verify that there is no SMB Signing on the server

B.

Ensure that there are no Opportunistic Lock issues

C.

Disable or reduce the connection timeout of MAPI prepopulation

D.

Investigate if there is a virus on a client trying to propagate itself

E.

Validate that NFS v2 broadcasts are enabled

The secure vault on the CMC appliance: (Select 3)

A.

Is always enabled and uses AES 256-bit encryption

B.

Can be enabled and supports 128, 192 and 256-bit AES encryption

C.

Is always enabled and opens by default at startup if the secure vault password has not been changed

D.

Has a default password which, if changed, means that it will need to be opened manually after each startup

E.

Contains all configuration and SSL information

A customer noticed that after deploying the Steelhead between their switch and router, OSPF takes much longer to re-converge after the router fails. Which RiOS feature can you enable to reduce the convergence time?

A.

Adjusting the OSPF “keep-alive” timers on the Steelhead appliance

B.

Configure Fail-To-Block on the Steelhead appliance

C.

Enable Link State Propagation

D.

Enable Link State Notification

E.

Configure Rapid Spanning Tree on the Steelhead appliance

Refer to the exhibit.

A customer is reporting that the first connection from a user to the server is failing. However, subsequent connections work properly and are optimized. How can this problem best be resolved?

A.

Fixed-target rule

B.

Enable RIP/OSPF on the routers

C.

Enable Simplified Routing

D.

Enable QoS

E.

Enable RIP/OSPF on the Steelhead appliances

What methods can the CMC appliance use to provide notification of CMC system events? (Select 3)

A.

Email

B.

RADIUS

C.

SNMP traps

D.

Syslog

To increase the high availability of a site at a remote office, you decided to install a second Steelhead appliance as an active/active serial cluster. However, after installing the second Steelhead appliance at the remote site, users started complaining about slow access to the data center. You have verified that this is not a duplex issue. At the data center location all users access the Internet which pass-through the Steelhead appliances. What is the most likely problem?

A.

SMB Signing

B.

Oplock issue

C.

The serial cluster Steelhead appliances are peering to each other

D.

Simplified routing was enabled on the secondary Steelhead appliance

E.

The datastore on the Steelhead appliances are wrapping

Refer to the exhibit.

A user from one of your branch offices reports connections to servers are failing after a new deployment. The exhibit shows how the Steelhead appliances have been deployed. Which of the following will most likely fix the issue? (Select 2)

A.

Fixed-target rule is needed on the client-side Steelhead appliance

B.

Change the WCCP to use Redirect Out instead of Redirect In

C.

Remove Redirect-IN from the LAN at the Branch Office

D.

Add Redirect-IN on the WAN at the HQ

E.

Remove fixed-target rule from the server-side Steelhead appliance