In a new in-path deployment, connections are listed as pass-through on the branch office Steelhead appliance. Which of the following is the likely cause of the problem?
1) Pass-through rule preventing optimization
2) Server-side Steelhead appliance is down
3) Satellite proxy not copying auto-discovery probes
4) Asymmetric routing is detected for the client/server flow
5) Duplex mismatch on WAN or LAN interface
Your Steelhead appliance deployment includes users accessing the Internet from branch offices with the traffic being back-hauled to the data center before going out to the Internet. However, HTTP latency optimization does not appear to be very effective, and in certain cases, is slower than without optimization. What settings might help with this Internet-bound traffic?
Given four Steelheads are deployed in a WCCP cluster and all Steelheads are optimizing traffic to and from the data center. Steelhead-A fails and only Steelhead-B and Steelhead-C are intercepting new connections while Steelhead-D is NOT optimizing any traffic. What is the likely problem?
Which of the following are valid WCCPv2 control messages? (Select 3)
In a recent in-path deployment, users are complaining that some of their CIFS drive-mapping connections do not appear to be optimized. Upon further analysis, you discover the file shares reside on a domain controller. The Steelhead appliances are deployed in a default configuration. Which of the following is the most likely cause of the problem?
What are the default port labels on an Interceptor appliance?
Which of the following configuration policies are supported on the CMC appliance? (Select 4)
While looking at the Current Connections page on a client-side Steelhead, you noticed that there is more CIFS traffic on the WAN than on the LAN for some connections. What may be the problem?
1) The source data is compressed or encrypted
2) File server not located on the same subnet as the server-side Steelhead
3) The Steelhead is counting both CIFS optimized and unoptimized traffic
4) CIFS read-ahead
5) CIFS write-behind
What can be monitored via the CMC appliance? (Select 2)
The default setting for “allow failure” in the Interceptor appliance version 2.0 is: (Select 2)
