Spring Sale Special - Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: sntaclus

Which lag command is used within route-map to redistribute routes that match with routes tagged with the specified tag numbers?

A.

match routing tag

B.

match all tag

C.

match route tag

D.

match tag

Refer to the exhibit.

Routers R1 and R2 are RFC 5036-based MPLS-enabled core routers MPLS IP is enabled globally on both routers OSPF with area 0 configuration is used as an interior routing protocol between the routers After new services were enabled on the MPLS network, LDP connectivity failed on R1 TCP/UDP port 711 is confirmed to be open Which two actions must the engineer take to correct the problem? (Choose two.)

A.

Configure network 10.10.140.192 0.0.0.0 arta 0 under the OSPF configuration on R2

B.

Configure mpls label protocol Idp under the Gi0/0 interface on R1

C.

Configure mpls ip under the Gi0'0 interface on R1

D.

Configure network 10.10.140.192 0.0.0.255 arta 0 under the OSPF configuration on R2

E.

Configure labtl mpls ip protocol tdp under the Gi0 0 interface on R1

Refer to the exhibit.

After troubleshooting an OSPF adjacency issue, routers 1, 2, and 3 have formed OSPF

neighbor relationships. Which statement about the configuration is true?

A.

Router 2 receives a Type 5 LSAs from router 1 for its connected subnets

B.

Router 2 uses router 3 as the next hop for 192.168.0.0/24

C.

Router 2 uses router 1 as the next hop for 192.168.0.0/24

D.

Router 2 receives a Type 7 LSAs from router 3 for its connected subnets

Which BGP well-known attributes are preserved between peers with a BGP confederation?

A.

origin and MED

B.

originator and origin

C.

next-hop and local-preference

D.

next-hop and weight

Refer to the exhibit.

Company_A hosts multiple online VoD platforms. R3 is connected to MAN with a 100 Mbps link R2 has only a 10 Mbps connection, but it has the lowest number of hops to R1 A network engineer must allow users in area 49.421e.2331 5548.7624 00 to access online library resources, using the best possible route toward the online platforms to guarantee the highest connection quality. After the engineer implements the requirements, they notice an excessive number of routes in the R4 routing table and high memory consumption on the router. Which two actions must the engineer take to resolve the issue? (Choose two.)

A.

Create an access list on R2 and redistribute all routes from L1 into L2.

B.

Configure summary-address area level-1-2 64.45.52.0 255.255.252.0 on R3.

C.

Create a route map on R3 and redistribute all routes from L2 into L1.

D.

Configure summary-address level-2 64.45.52.0 0.0.3.255 on R2.

E.

Configure summary-address 64.45.52.0 255 255.252.0 level-1 on R3

Refer to the exhibit. R21 is a multicast source sending multicast traffic 224.1.1.1 to R23, with RP22 serving as the rendezvous point inside AS65222. A network engineer noticed that when R21 goes down, R12 in AS65111 starts to send the same multicast group 224.1.1.1 through RP11. Which action resolves the issue ?

A.

Block service groups 224.0.1.39 and 224.0.1.40 between the two autonomous systems

B.

Disable PIM parse mode between RP11 and RP22 in the two autonomous systems.

C.

Advertise RP2 with a high local preference in AS65222.

D.

Enable passive intertaoe under EIGRP between the two autonomous systems.

Refer to the exhibit.

EBGP peering is up between BGP AS 65101 and BGP AS 65201 The service provider expects traffic convergence within 300ms between the two autonomous systems but the network operations team sees that route and traffic convergence is too slow Which two actions improve the convergence time? (Choose two.)

A.

Change the bfd multiplier value to 3 on routers RN and RM

B.

Configure fall-over bfd under the BGP instance for BGP neighbors on RN

C.

Configure bfd interval 50 min_rx 100 multiplier 6 on the connected interfaces on RN and RM

D.

Configure bfd interval 50 min_rx 50 multiplier 6 on the connected interfaces on RL and RY

E.

Change the bfd interval value to 100ms on routers RN and RM

Refer to the exhibit.

The extension header of the IPv6 header is ignored when which value is equal to zero?

A.

Segments Left

B.

Hdr Ext Len

C.

Routing Type

D.

Next Header

Refer to the exhibit.

An administrator is troubleshooting network issues on a customer’s network PE1 cannot form an LDP relationship with PE2 using LDP ID 192 168.1.1. Due to this connectivity issue, the customer’s routes behind both PE routers cannot be exchanged. Which action must the administrator take to correct the problem?

A.

Configure PE2 to automatically select its own LDP router ID with 192.168.1.1.

B.

Create a targeted LDP session on PE2 to override the missing routing table entry on PEL

C.

Configure PE1 with a static route to 192 168.1.1.

D.

Enable LDP session protection on the link that P1 uses as the next hop to PE2.

Refer to the exhibit.

Routers R1, R2. R3, and R4 have been configured to run OSPF. and router R5 is running EIGRP Traffic from R1 to R5 is expected to pass via R4. but OSPF routing has calculated the best path via R3. Which action corrects the problem?

A.

Configure R3 to use metric-type 1 with a higher metric than R4.

B.

Configure R1 with a static route to the R5 networks and set R5 as the next hop.

C.

Reconfigure R1 in Area 0.

D.

Change the metric-type value on R3 to 2.