Summer Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: exc65

examout.co

Which of the following commands is used to create a new Epipe service?

A.

configure epipe service-id customer customer-id create

B.

configure service epipe service-id customer customer-id create

C.

configure epipe service-id create

D.

configure epipe service-id customer customer-id create

E.

configure epipe service service-id customer customer-id create

Service tunnels and transport tunnels are bidirectional and only require the operator to configure the tunnel on one router.

A.

TRUE

B.

FALSE

The terms "customer" and "service" are used synonymously when describing a service implementation on the Alcatel-Lucent 7750 SR.

A.

TRUE

B.

FALSE

Which of the following are characteristics of an IES service? (Choose 2)

A.

A virtual routing/forwarding table is created per IES service.

B.

Only one IES service can be created for a single customer ID.

C.

More than one IP interface can be created within a single IES service.

D.

All IP interfaces created within the same IES service belong to the same customer

A transport tunnel can either use an MPLS or GRE encapsulation.

A.

TRUE

B.

FALSE

Which of the following best describes a VPWS?

A.

Layer 3 direct Internet access service.

B.

Layer 2 point-to-point service.

C.

Layer 2 multipoint-to-multipoint service.

D.

Layer 3 IP multipoint-to-multipoint VPN service.

When a tagged packet is received on a SAP configured with dot1q encapsulation, the VLAN tag must match the value configured on the SAP in order to be forwarded.

A.

TRUE

B.

FALSE

Which of the following best describes the label stack for a packet in the VPRN context?

A.

An outer label and a transport label.

B.

An inner label and a service label.

C.

A transport label and a service label.

D.

An MPLS transport label

In a Layer 2 VPN service, the FCS is stripped when a customer packet arrives at the ingress PE and regenerated on egress.

A.

TRUE

B.

FALSE

Which of the following statements best describes an FDB used in a VPLS service?

A.

A VPLS service does not use an FDB.

B.

An FDB is maintained on the PE router to track MAC addresses learned from all traffic through the router.

C.

An FDB is maintained on the PE router to track MAC addresses learned from all VPLS services on the router.

D.

A separate FDB is maintained for each VPLS service to track MAC addresses learned from each service.

E.

For each VPLS service, two FDBs are maintained to track MAC addresses; one for unicast traffic and one for multicast and broadcast traffic.