Summer Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: exc65

Refer to the exhibit.

The network engineer is performing end-to-end MPLS path testing with these conditions:

• Users must perform MPLS OAM for all available same-cost paths from R1 to R4.

• Traceroute operations must return all of the next-hop IP details.

Which configuration meets these requirements?

A.

traceroute mpls ipv4 10.10.10.4 255.255.255.255 verbose

B.

traceroute mpls multipath ipv4 10.10.10.4 255.255.255.255

C.

traceroute mpls multipath ipv4 10.10.10.4 255.255.255.255 verbose

D.

traceroute mpls ipv4 10.10.10.4 255.255.255.255 source 10.10.10.1

Refer to the exhibit. Which additional configuration must an engineer to the adge router to inject a default router into the MP-BGP address family for the internet_Shared_Services dedicated VRF?

A)

B)

C)

D)

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Refer to the exhibit. A network engineer must deny access from spoofed addresses to the LAN. The edge router currently has two active BGP sessions established with Tier 1 ISP_A. Due to asymmetric routing, no ACL is configured on either interface. Which two configurations must the engineer perform on the edge router to complete the task? (Choose two.)

A.

ip verify unicast source reachable-via tx under FA0/0

B.

ip verify unicast source reachable-via under FA0/1

C.

ip verify unicast source reachable-via any under FA0/1

D.

ip verify unicast source reachable-via both under FA0/0

E.

ip verify unicast source reachable-via any under FA0/0

An engineer is implementing IGMP with SSM on a multicampus network that supports video streaming. Which task must the engineer perform as part of the process?

A.

Configure the network to use IGMPv3.

B.

Configure the network to use bidirectional PIM.

C.

Configure an RP that uses static assignments only.

D.

Configure the network to use the PIM bsr-candidate

A network administrator must monitor network usage to provide optimal performance to the network end users when the network is under heavy load. The administrator asked the engineer to install a new server to receive SNMP traps at destination 192.168.1.2. Which configuration must the engineer apply so that all traps are sent to the new server?

A.

snmp-server enable traps entity

snmp-server host 192.168.1.2 public

B.

snmp-server enable traps bgp

snmp-server host 192.168.1.2 public

C.

snmp-server enable traps isdn

snmp-server host 192.168.1.2 public

D.

snmp-server enable traps

snmp-server host 192.168.1.2 public

A mod-size service provider uses L2VPN as its standard for connectivity between offices. A small company wants the service provider to connect the company’s two sites across the service provider core. To meet service requirements, the service provider must extend the layer 2 domain between the company’s two locations. Which configuration must the engineer apply to implement an attachment circuit between the two sites using a VLAN tag of 12?

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Refer to the exhibit. A service provider engineer Is configuring the connection between CE1 and CE2. AS 200 of the service provider and AS 100 of enterprise ABC should connect using BGP. The engineer already completed the configuration of VRF RT 100:10 of enterprise ABC. Which configuration must the engineer apply on PE1 to meet the requirement?

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Refer to the exhibit. Router P4 and P5 receive the 0.0.0.0/0 route from the ISP via eBGP peering P4 is the primary Internet gateway router, and P5 is its Backup. P5 is already advertising a default route into OSPF domain. Which configuration must Be applied to P4 so that advertises a default route Into OSPF and Becomes me primary internet gateway for the network?

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Which CLI mode must be used to configure the BGP keychain in Cisco IOS XR software?

A.

global configuration mode

B.

routing configuration mode

C.

BGP neighbor configuration

D.

mode BGP address-family configuration mode

A router is configured to perform MPLS LDP graceful restart.

Which three steps are included when the RP sends an LDP initialization to a neighbor to establish an LDP session? (Choose three)

A.

Reconnect Timeout field

B.

Learn from Neighbor (N) flag, set to 1

C.

Graceful restart capability in OPEN message

D.

Recovery Time field

E.

Learn from Network (L.) flage, set to 1

F.

Type-9 LSA