Refer to the exhibit.
After these configurations were applied to routers R1 and R2. the two devices cannot form a neighbor relationship What is the reason tor the problem?
Drag and drop the BGP attributes from the left into the order of route selection preference on the right.
Refer to the exhibit.
All backbone interfaces on the network are in VRF_MPLS and ip rsvp signalling hello is preconfigured on all MPLS routers in the network. After router R2 is upgraded and its configuration restored from backup. LSP signaled via RSVP that the tunnel from R1 had been tom down The network engineer confirmed IP reachability line the backbone network Which action must the engineer take to fix the issue?
Refer to the exhibit.
OSPF is running in the network, which spans multiple areas as shown, and all OSPF neighbors are established. Hosts that reside on the LAN on R1 are trying to reach a server connected to R5, but R1 cannot reach the R5 routes. The server must maintain a TCP connection with the hosts. Which action must the engineer take to resolve the issue?
A network administrator working for a private service provider with an employee ID 4784 41 907 wants to configure timers for the BGP process on their Cisco IOS XE router Which configuration follows guideline timer recommendations and is a valid BGP timer deployment?
A)
B)
C)
D)
How does the SRv6 IS-IS Flexible Algorithm function on the data plane?
When deploying a nationwide network of routers, what is the benefit of using BGP confederations?
Refer to the exhibit.
IS-IS is the IGP for the network, where routers R1. R2 R3, and R4 are Level 1 routers in Area 12 and routers R5 and R6 are Level 2 routers m area 16 According to the network design router R1 must send traffic to R6 using R4 as its next hop To meet the requirement, a network engineer configured route filtering on R2 to prevent the route to R6 from being advertised from R2 However R1 is still using R2 as the next hop Which action must the engineer take to resolve the issue?
What is the purpose of the confederation identifier in a BGP confederation?
Refer to the exhibit.
A network engineer applied configuration on R5 to summarize all OSPF routes, but R4 is still receiving specific routes from R5. The engineer has confirmed that both R5 and R4 routers are configured with correct summarization configuration but R5 Is not sending the summary routes What action must the engineer take to fix the problem?
