What is an advantage of using auto mode versus static mode of power allocation when an access point is connected to a PoE switch port?
Which set of elements are verified by the controller to confirm the identity of edge devices?
Refer to the exhibit A WAN Edge device was recently added to vManage but a control connection could not be established Which action resolves this issue?
Drag and drop the Cisco SD-WAN components from the left onto their functions on the right.
An engineer is creating a policy for VPN1 users. Their scavenger traffic at site 101 must pass through a firewall. Which two match conditions must be selected to enable this policy? (Choose two.)
Which policy blocks TLOCs from remotes and allows TLOCs from the data center to form hub-and-spoke peering?
Which two mechanisms are used by vManage to ensure that the certificate serial number of the WAN Edge router that is needed to authenticate is listed in the WAN Edge Authorized Señal Number Hst’ (Choose two)
Refer to the exhibit.
Customer XYZ cannot provison dual connectivity on both Its routers due to budget constratnts but wants to use tnth RI and R2 interface for users behind them for load toward the hub site Which configurauon achieves this objectives?
A)
B)
C)
D)
Which protocol is used to measure loss latency, Jitter, and liveliness of the tunnel between WAN Edge router peers?
Which pathway under Monitor > Network > Select Device is used to verify service insertion configuration?
