A network engineer created a new wireless network that will be used for guest access. The corporate network must utilize all rates. The guest network must use only lower rates instead of 802.11n data rates. To what must the WMM policy of the WLAN be set to accomplish this task?
A customer has a distributed wireless deployment model where the WLCs are located in the data centers. Because the file servers are located in the data center, the traffic from the corporate WLAN “Corp-401266017” must go through the controllers, where the guest WLAN “Guest-19283746” traffic must use the local Internet line installed in each office. Which configuration will accomplish this task?
Company XYZ recently migrated from legacy WLCs to Cisco Catalyst 9800 WLCs. According to the global standard, Internet bandwidth must be limited to 5 Mbps for each guest client. To which Cisco Catalyst 9800 WLC configuration component must the QoS requirement be added?
A network engineer needs to configure multicast in the network. The implementation will use multiple multicast groups and PIM routers. Which address provides automatic discovery of the best RP for each multicast group?
An engineer is implementing profiling for BYOD devices using Cisco ISE. When using a distributed model, which persona must the engineer configure with the profiling service?
Which three properties are used for client profiling of wireless clients? (Choose three.)
An engineer is planning an image upgrade of the WLC, and hundreds of APs are spread across remote sites with limited WAN bandwidth. The engineer must minimize the WAN utilization for this upgrade. Which approach must be used for the AP image upgrade?
What two actions must be taken by an engineer configuring wireless Identity-Based Networking for a WLAN to enable VLAN tagging? (Choose two.)
A customer configures iPSK for use with a Cisco Catalyst 9800 Series controller. The configuration is complete, but the wireless client fails to authenticate to the network. Which implementation resolves this issue?
WPA2 Enterprise with 802.1X is being used for clients to authenticate to a wireless network through a Cisco ISE server. For security reasons, the network engineer wants to ensure that only PEAP authentication is used. The engineer sent instructions to clients on how to configure the supplicants, but the ISE logs still show users authenticating using EAP-FAST. Which action ensures that access to the network is restricted for these users unless the correct authentication mechanism is configured?