Summer Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: exc65

examout.co

What Is a typical use case for the deployment of a VMware SU-WAN Partner Gateway?

A.

Provide connectivity between multiple enterprise customers over private circuits

B.

Get improved flow analytics for all traffic in the SD-WAN network

C.

Interconnect branches/remote sites of a single enterprise customer to the internet

D.

Provide mite transport m a service provider backbone tor interconnecting a global customer SD-WAN branches.

A customer is using VMware vSphere in their data center. An administrator is asked to deploy SD-WAN Edges for a Proof of Concept as soon as possible.

Which deployment option is the roost cost and time effective?

A.

Deploy a virtual appliance on ESXi

B.

Purchase bare metal Edge

C.

Deploy a virtual appliance in AWS

D.

Deploy a virtual appliance on KVM

Which statement describes a characteristic of VMware SU-WAN Edge (VCL) clustering?

A.

One VCE cluster can be formed with both virtual and hardware at the same lime

B.

A VCE cluster requires one dedicated interface for HA sync

C.

VCF clusters member sync flow tables between themselves.

D.

VCE cluster members should have unique IP addresses on its WAN interfaces

A customer has a 10,000 branch site requirement arid must use a hub cluster in their design.

Which Mware SO- WAN best practice should be used when designing the cluster?

A.

BGP on WAN side

B.

Static routing

C.

MP BGP south bound

D.

BGP on LAN side

Due to very strict security policies an enterprise customer is looking for an on-premises deployment of the VMware SD-WAN Orchestrator and Controllers. Customer data is not expected to flow through this Controller, however it is desirable that management plane traffic towards the Orchestrator coming from VMware SD-WAN Edges can take the overlay tunnels through this controls.

What are some of the needed steps to achieve the requirements above?

A.

Under gateway configuration -> Configure the Gateway roles as Control Plane, disable Data Plane and enable management plane forward

B.

Under gateway configuration -> Configure the Gateway roles as Control Plane, disable Data Plane and add static host routes with NAT hand off settings porting to the Orchestrator IPs under Partner Gateway advanced hand off settings

C.

Under gateway configuration -> Configure the Gateway roles as Control-Plane, enable Data Plane and Partner Gateway role and add static host mules with NAT hand off settings pointing to the Orchestrator IPs under Partner Gateway advanced hand off settings

D.

Under gateway configuration -> Configure the Gateway roles as Control-Plane, enable Data Plant- and Partner Gateway role and add a static default route with NAT hand off settings under Partner Gateway advanced hand oft settings