Summer Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: exc65

MPLS is used to label packets instead of IP forwarding. Which of the following descriptions about MPLS packet encapsulation are correct?

A.

The Type field in the ETH header is set to 0x8847 to indicate that it is followed by MPLS label encapsulation

B.

The nested encapsulation of MPLS can only be two layers, PW and Tunnel two layers of labels

C.

The MPLS label of the Tunnel carrying the PW, where the S bit is set to 1

D.

IP packets can be directly carried on the Tunnel

The ARP protocol is a broadcast-based protocol through which the host can dynamically discover the MAC address corresponding to an address.

A.

True

B.

False

Where in the L2/L3 node is the VLAN in the Layer 2 header stripped in the packet sent by the base station in the LTE solution?

A.

L3VE sub-interface

B.

Network side interface

C.

Network side interface

D.

LOOPBACK interface

In OptⅸPTN3900, which of the following slots can MQ1 be placed in?

A.

Slot5

B.

Slot6

C.

Slot9

D.

Slot26

Which of the following items can be included in the upgradeable boards of the PTN3900 NE upgrade operation?

A.

Main control board

B.

Cross Plate

C.

Business Processing Board

D.

Fan Board

After the LAN is divided into VLANs, if computers in different VLANs want to communicate, IP routing needs to be established. Which of the following solutions can be used?

A.

STP

B.

L3 Switch

C.

L2 switch + router

D.

GVRP

Which of the following items are the main functions of the U2000 network management?

A.

Topology Management

B.

Performance Management

C.

Alarm Management

D.

End-to-end business management

E.

Resource management

The frame rate of STM-1, STM-4, STM-16, STM-64 signals are all the same 8000 frames/sec.

A.

True

B.

False

In the PHB̂ category of common FTN service flows, which of the following corresponds to the voice service?

A.

CS

B.

AF

C.

BE

D.

EF

Which of the following statements about multiplexed partial range error indication (MS-REI) is true

① B2 byte represents the transmission channel.

② M1 byte folder indicates the transmission channel

③ MS-REI is sent from the receiver to the source.

④ MS-REI is transmitted from source to receiver

⑤ Indicates the number of bit errors detected by the receiver after receiving the MS signal.

A.

①④⑤

B.

②④⑤

C.

①③⑤

D.

②③⑤