Refer to the exhibit.
What can an administrator determine from this Aruba device output?
Which protocol is used to tunnel user traffic when an administrator implements tunneled mode between an ArubaOS-Switch and an Aruba Mobility Controller (MC)?
Refer to the exhibit.
An administrator sets up a cluster of Aruba Mobility Controllers (MCs). What can the administrator determine about the cluster from the command output shown in the exhibit?
Which IEEE standard should user devices support to implement Fast BSS Transition when a network implements wireless roaming (mobility)?
An administrator configures the MultiZone feature for a company network, where a mobility cluster is the primary zone and a standalone controller in the company’s DMZ represents a secondary data zone. The administrator configures two AP Groups and respective VAPs for the zones on the Mobility Master (MM) in the primary zone. When the APs boot up and establish connections to both zones, the administrator notices that no data connections are established to the data zone.
What must the administrator do to fix this problem?
An administrator implements a per-port tunneled node configuration for an Aruba Mobility Controller (MC) that runs ArubaOS 8.x. The controller performs both MAC and 802.1X authentication.
What must the administrator specify on the controller to allow for 802.1X authentication to succeed?
An administrator currently manages an L2 cluster with Aruba Mobility Controllers (MCs) that run ArubaOS 8.x. What happens when the administrator enables AP load balancing?
An administrator wants to determine if an IPSec session is established. In order to tunnel and protect the GRE data traffic between a RAP and an Aruba Mobility Controller (MC). Which MC command provides this information?
Which protocol communicates RF neighborhood information to an Aruba Mobility Master (MM) for use by AirMatch?
Which Aruba Mobility Controller (MC) command should an administrator execute to determine whether an ArubaOS-Switch successfully registers to an MC?
