Summer Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: exc65

One of the two members of a device group has been decommissioned. The BIG-IP Administrator tries to

delete the device group, but is unsuccessful.

Prior to removing the device group, which action should be performed?

A.

Disable the device group

B.

Remove all members from the device group

C.

Remove the decommissioned device from the device group

D.

Make sure all members of the device group are in sync

A site wishes to perform source address translation on packets from some clients but not others. The determination is not based on the client's IP address, but on the virtual servers their packets arrive on. What could best accomplish this goal?

A.

A SNAT for all addresses could be defined, and then disable the SNAT processing for select VLANs.

B.

Some virtual servers could be associated with SNAT pools and others not associated with SNAT pools.

C.

The decision to perform source address translation is always based on VLAN. Thus, the goal cannot be achieved.

D.

The decision to perform source address translation is always based on a client's address (or network). Thus, this goal cannot be achieved.

A BIG-IP Administrator contacts F5 Support, which identifies a suspected hardware failure. Which information should the BIG-IP Administrator provide to F5 Support?

A.

Qkview, EUD output

B.

Qkview, UCS archive, core files

C.

Qkview, part numbers for failed components

D.

Qkview, packet capture, UCS archive

Refer to the exhibit.

A pool member fails the monitor checks for about 30 minutes and then starts passing the monitor

checks. New traffic is Not being sent to the pool member.

What is the likely reason for this problem?

A.

The pool member is disabled

B.

Monitor Type is TCP Half Open

C.

Manual resume is enabled

D.

Time Until Up is zero

What is the purpose of MAC masquerading?

A.

to prevent ARP cache errors

B.

to minimize ARP entries on routers

C.

to minimize connection loss due to ARP cache refresh delays

D.

to allow both BIGIP devices to simultaneously use the same MAC address

On the VCMP system, a BIG-IP host administrator imports a new ISO image into the host's /shared/images folder. The new ISO images that reside on the vCMP host are available for installation on the guest. How should the BIG-IP Administrator install one image from within the guest?

A.

Install the new software on the host and wait for it to automatically be installed on all guests.

B.

Run the following command on guest

tmsh install sys software block-device-image image_name volume < volume_name>

C.

Run the following command on guest

tmsh install sys software image image_name volume < volume_name>

D.

Run the following command on host

tmsh install sys software block-device-image image_name volume < volume_name>

In the BIG-IP Configuration Utility, a user requests a single screen view to determine the status of all Virtual Servers and associated pool members, as well as any iRules in use. Where should the BIG-IP Administrator instruct the user to find this view?

A.

Local Traffic > Monitors

B.

Local Traffic > Virtual Servers

C.

Local Traffic > Network Map

D.

Statistics

All pool members are online. All other virtual server settings are at default What might after the load balancing behavior?

A.

enabing SNAT automap

B.

enabing a falback host in the http profile

C.

adding a oneconnect profile

D.

adding a persistence profile

The BIG-IP Administrator configures an HTTP monitor with a specific receive string. The status is marked

'down'.

Which tool should the administrator use to identify the problem?

A.

Ping

B.

Health

C.

tcpdump

D.

ifconfig

A virtual server is defined using a source address based persistence profile. The last five connections were A, B, C, A, C . Given the conditions shown in the graphic, if a client with IP address 205.12.45.52 opens a connection to the virtual server, which member will be used for the connection?

A.

10.10.20.1:80

B.

10.10.20.2:80

C.

10.10.20.3:80

D.

10.10.20.4:80

E.

10.10.20.5:80