Weekend Sale - Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: sntaclus

examout.co

Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?

A.

Switch

B.

Transceiver

C.

NIC

D.

Port

What accurately describes the comparison between stacking and VLT?

A.

VLT allows for more physical devices to appear as one virtual device than stacking does.

B.

Stacked switches share a common control plane while VLT peers maintain their own control plane.

C.

Stacked switches and VLT peers allow “single pane of glass” management by maintaining a single control plane.

D.

Both VLT and stacking allow devices to use different versions of firmware provided that the switch family/ series is the same.

Which port and protocol is used by NTP to communicate?

A.

TCP port 123 for both the source and destination

B.

TCP port 123 for the source and TCP port 80 for the destination

C.

UDP port 123 for both the source and destination

D.

UDP port 123 for the source and TCP port 80 for the destination

A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch.

Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?

A.

Switch checks its routing table and forwards the packet accordingly.

B.

Switch duplicates the packet and sends it to all interfaces.

C.

Switch replies back to the source with an ICMP Reject packet.

D.

Switch drops the packet.

On which OSI layers do standard ACL filters operate?

A.

2 and 3

B.

2 and 7

C.

3 and 4

D.

4 and 7

At which layer of the OSI model is the Rapid Spanning Tree protocol used to prevent switching loops?

A.

Physical

B.

Network

C.

Data Link

D.

Transport

On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

A.

C9000 Series

B.

N-Series

C.

S-Series

D.

Z-Series

What accurately describes OSPF?

A.

Interior gateway link-state protocol

B.

Exterior gateway distance-vector protocol

C.

Interior gateway distance-vector protocol

D.

Interior gateway path-vector protocol