An engineer implements an environment with multiple traffic types on a consolidated I/O link between Cisco Nexus 9000 Series Switch and MDS 9000 Series Switch The configuration must meet these requirements:
The unified I/O link must support LAN and SAN traffic.
A single, multipurpose Ethernet transport must be used.
The configuration must discard MAC addresses that are not part of the current fabric.
The QoS markings must be preserved.
Which configuration set meets the requirements?
An engineer must assign a device alias of Marketing to a Fibre Channel port that has a worldwide name of 21:00:00:00:11:11:22:22 on a Cisco MDS 9000 Series Switch. Which two commands accomplish this goal? (Choose two.)
Which storage solution allows multiple users to access files directly on a storage array over a LAN network?
DNS server with IP address 192.168.1.1 is deployed in a data center A network engineer must configure a Cisco UCS Fabric Interconnect to use this DNS. Which configuration should be applied?
Service degradation is reported on a VM that is deployed on a Cisco UCS blade server. The traffic from the vNIC is required to SPAN in both directions to a packet analyzer that is connected to UCS-A slot 2 port 12. Which two commands are needed to complete the configuration? (Choose two.)
An engineer must use Ansible to standardize VRF configuration across the data center. The devices that must be configured are listed in the variable called HOST-NXOS. Also, all existing VRF configurations must be removed. Drag and drop the code snippets from the right onto the blanks in the code to create an Ansible play that accomplishes these goals. Not all code snippets are used.
A storage administrator notices an increasing number of storage targets that unexpectedly reach capacity, causing periodic service interruptions The administrator must now create and submit a daily report of the environment that shows the status of the storage targets with the highest capacities Which solution provides this information?
Which feature of Cisco Nexus Dashboard permits users to switch between site controllers of Cisco ACI?
An engineer configured an environment that contains the vPC and non-vPC switches. However, it was noticed that the downstream non-vPC switches do not receive the same STP bridge ID from the upstream vPC switch peers. Which vPC feature must be implemented to ensure that vPC and non-vPC switches receive the same STP bridge ID from the upstream vPC switch peers?
Which Cisco solution provides SAN slow-drain analysis?
