The Cisco SD-WAN engineer is configuring service chaining for a next-generation firewall located at the headquarters. Which configuration creates the service?
A)
B)
C)
D)
Refer to the exhibit, which configuration configures IPsec tunnels in active and standby?
Refer to the exhibit.
Which shaping-rate does the engineer use to shape traffic at 9 Mbps?
A network administrator is creating an OMP feature template from the vManage GUI to be applied to WAN edge routers. Which configuration attribute will avoid the redistribution of the routes back into the OMP from the LAN side?
Refer to the exhibit An engineer must configure a QoS policy between me hub and site A (spoke) over a standard internet circuit where traffic shaping is adjusted automatically based on evaiiabk» bandwidth Which configuration meets the requirement?
Refer to the exhibit.
The network design team has advised to use private IP addresses and private colors over the SP circuit for the data plane connections. The Public IP should be used for control connections. Which configuration should be applied at SiteA to achieve this task?
Which two hardware platforms support Cisco IOS XE SD-WAN images'' (Choose two)
When redistribution is configured between OMP and BGP at two Data Center sites that have Direct Connection interlink, which step avoids learning the same routes on WAN Edge routers of the DCs from LAN?
Refer to the exhibit.
An SD-WAN customer has 23 sites connected to its hub site, where a pair of WAN Edge devices and controllers are placed. All other branches have a single WAN Edge device connected to multiprotocol label switching (MPLS) and public internet circuits. An engineer must configure application-aware routing for a branch that has MPLS and public internet circuits provisioned using feature templates. The requirements for application-aware routing are:
All types of traffic prefers using public-internet circuit.
If the average latency reaches 100 ms, jitter 85 ms, and packet loss 5%, then video and voice traffic switches to the MPLS circuit.
Which feature template must be configured or modified in addition to configuring a centralized policy?
An organization wants to discover monitor and track the applications running on the WAN Edge device on the LAN Which configuration achieves this goal?
