Which command will be used in order to restart Orchestrator service only?
Complete the sentence: Orchestrators works as...
What cannot be a reason for DETACHED status of Appliance when runningasg monitorcommand?
What is the minimal amount of cables needed in order to connect an Appliance to an Orchestrator?
What is the basic installation sequence of the Orchestrator in case of single Orchestrator?
1. Create a Security Group
2. Configure Default Gateway
3. Connect with Serial Console cable to the Orchestrator
4. Configure IP for one of its Management interfaces
5. Connect an appliance to a downlink port
6. Change Orchestrator amount to 1
7. Browse to the Orchestrator’s WebUI
What kinds of transceivers are supported on Orchestrator MHO-140?
There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there's no NAT and no VPN, what would be proportion of
traffic distribution done by Orchestrator?
What will happen in case of NAT of the traffic passing through Management network?
What is the purpose of Management ports located on the Rear Panel of the Orchestrator MHO-140?
There are two 10Gbps dual-port NIC installed on a 6800 appliance. Which interfaces should be connected to Orchestrator 1 for downlinks' intra-orchestrator redundancy when using two Orchestrators?