You are attempting to set up monitoring on servers running Red Hat SELinux 7.1. You are unable to turn off the iptables firewall.
After getting a Linux robot up and running, you notice that the controller, spooler, and hdb robot probes all
have green ports in infrastructure Manager and the controller and remote hub show no errors. However, you cannot open the controller GUI or contact it through the hub-to-robot connection. Only the connection from the robot to the hub, port 48002, works using Telnet. To address this issue, what do you need to do?
You ate configuring high availability (HA) for a tier 3 robot hub. On the secondary HA hub, what is the correct
configuration for Attach queues?
You can save time during robot deployment by using an answer file, which can be used with the CA UIM native installer or third-party tools.
Which variables are REQUIRED in the answer file? (Choose four.)
Which component requires port 4334 for connecting to the primary hub?
When planning your monitoring strategy, which guideline should you follow?
How is a connection established when difficulties with a hub-to-hub tunnel connection occur because of a bad password?
CA UIM fails to communicate with a device hosted on a network protected by a firewall. Which command is used to test the routing from the CA UIM server to the device and from the device to the CA UIM server?
To enable multi-tenancy at every level of the UIM architecture, what is the best practice for setting the origin?
CA UIM server components automate the discovery of hosts and devices throughout your network. For
discovery, which protocols are supported?
What is the minimum supported configuration to install CA UIM and have all core functionality available?