An alert about RX errors on eth2 on a node is reported in the cluster. The administrator logs in to the CVM in question, checks the ping_* files in the data/logs/syststats folder, and notices intermittent ping loss.
The node in question has the following network configuration:
Which action should be used to troubleshoot without disrupting the VMs running on this node?
An administrator has a 4-node Nutanix cluster running on AHV. The administrator creates
a new storage container and makes that all available to all hosts.
Which storage protocol is used for Virtual Machines to access virtual disks on the storage container?
A customer needs a DR solution designed around the following requirements:
• There are 8 ms of latency between Sites A and B
• The administrator needs the shortest RPO/RTO possible
• Application consistent snapshots are required
• Use of Nutanix VSS
Which Data Protection Method should be used?
An organizations Nutanix Cluster is based on VMware vSphere. The cluster is configured to download software updates automatically. The administration needs to verify and eventually upgrade VMware hypervisor via Prism Ul.
After logging in to Prism, the administrator receives the message shown:
No available versions for upgrade
What is causing the current state?
An administrator is trying to correct high cluster IOPs and Cluster Controller Latency. Networking is the suspected issue.
Which networking parameters should be configured in the Nutanix cluster?
A systems administrator configures a protection domain replication between two Nutanix clusters. After the first successful replication, the administrator tests DR by clicking activate on the remote cluster.
While VMs are active on the remote cluster, the protection domain is marked as active on both clusters.
What steps are required to return both clusters to their original state?
An Administrator has created a Volume Group for a specific VM on an AHV Cluster.
What is the next step required to user vDisk in the VM?
Which method can be used to migrate a VM configured for UEFI-boot from a Nutanix Hyper-V cluster to AHV?
An administrator is planning to deploy a Nutanix cluster to support a few high-performance VMs. This deployment will have the following considerations:
• Individual VMs will likely generate network throughputs in the range of 90-100Mbps
• Due to the configuration of the VMs, it is unlikely that a node will host more than one or two of them at a time
• Individual VMs will communicate with only a few (one or two) remote hosts at a time
• Multicast will not be used in the environment
• The hosts are connected via two 1GbE network connections
How should the administrator configure the network bonds to meet this requirement while maintaining the simplest switch configuration?
An administrator is migrating 5MB shares from a third-party platform to Nutanix Files with the following characteristics:
• Shares contain user profile directories
• DFS-N will be used
How should the administrator create target shares for this migration?
