Weekend Sale - Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: sntaclus

An administrator has a 32-node hybrid cluster with CPU, RAM and storage utilization of 80%. A database VM is configured with VM Flash.

What is causing this IO latency?

A.

Controller VM is experiencing high CPU ready time.

B.

Curator scans causes by ILM constantly moving data.

C.

VM Flash Mode reduces SSD tier capacity for VMs.

D.

Database VM is experiencing high CPU ready time.

The networking team makes changes to the Top of Rack switches to which the Nutanix cluster are attached. A few VMs are able to communicate with each other on the same node but are unable to connect to other parts of the network.

What is the likely cause of this issue?

A.

There is a VLAN misconfiguration on the VMs.

B.

The vNIC port is disconnected on the affected VMs.

C.

There is a VLAN misconfiguration on the switch.

D.

Jumbo Frame are misconfigured across ports.

An administrator is deploying an application using Nutanix Volumes. After configuring the volume group and connecting the guest's iSCSI initiator to the volume group, they begin performance testing.

The administrator learns that performance on the virtual disk attached to the iSCSI initiator is far less than that of a virtual disk connected directly to the VM.

Which situation is causing this condition?

A.

The VM's iSCSI traffic is being routed to the data services IP subnet

B.

The performance test is generating small block random 10.

C.

The duster data services IP address is a bottleneck, shared with other iSCSI traffic

D.

Data Locality ensures that VM attached disks are always faster than iSCSI volumes.

An administrator manages the following two Nutanix AOS 5.15 cluster environment:

• Corp-cluster-01

• Corp-cluster-02

The VM images must be available only on Corp-cluster-01, but cannot be checked out to cluster Corp-cluster-02. The images also cannot be checked out to any other clusters that are registered with Prism Central in the future.

Which two configuration settings must the administrator choose when creating the image placement policy that satisfies the stated requirements? (Choose two.)

A.

Create an image placement policy that identifies cluster Corp-cluster-01 as the target cluster

B.

Set the policy enforcement to Soft.

C.

Set the policy enforcement to Hard.

D.

Create an image placement policy that identifies cluster Corp-cluster-02 as the target cluster.

An alert about RX errors on eth2 on a node is reported in the cluster. The administrator logs in to the CVM in question, checks the ping_* files in the data/logs/syststats folder, and notices intermittent ping loss.

The node in question has the following network configuration:

Which action should be used to troubleshoot without disrupting the VMs running on this node?

A.

Replace the cable from eth2 to the switch

B.

Remove eth3 from br0-up and monitor for new alerts

C.

Check the port on the switch side for any errors

D.

Enable balance-s1b on br0-up and monitor if a problem persists

An administrator knows that the disks in a cluster are out of date and a new firmware is available. For security reasons, these clusters do not have access to the Internet.

Which two steps must be completed to update the firmware? (Choose two.)

A.

Configure LCM with a URL to access the firmware bundle.

B.

Download a dark site bundle and stage it on an internal webserver.

C.

Download the updated firmware .tgz file from the Nutanix portal.

D.

Select Upgrade Software, then select disks and upload the updated firmware.

A customer has NearSync configured. When the administrator tries to restore a snapshot from 3 minutes ago, it is not available. The snapshots are happening at 15-minute intervals instead of at the 5-minute configured interval. When the protection domain was initially set up, the snapshots were happening at the expected 5-minute interval.

What should the customer do to enable the snapshots to happen at the expected interval?

A.

Utilize Metro Availability to meet this requirement

B.

Change the protection domain to use Async DR

C.

Fix a connectivity issue because the protection domain reverted to Async

D.

Configure the protection domain to take snapshots on 15-minute intervals

Over the period of 2 to 3 weeks, a cluster displays the following:

•Periods where Warning Alerts of memory usage over 75% are asserted

•Periods where Critical Warnings of memory usage over 90% are asserted

•Periods of slow of frozen VDI desktops have caused work stoppage or slowdown

•VDI clones have periodically not powered up when called, causing work stoppage

Which steps should be used to prioritize the administrator’s troubleshooting efforts?

A.

•Assess resource health on Hardware page

•Review the Analysis page for memory usage demand

•Determine the VDI workload-to-host affinity across the cluster

B.

•Analyze Alert Pages for a root cause of memory problem

•Analyze VM table page to access the VM functionality

•Analyze the VDI Clone properties for possible VDI Workload stress

C.

•Check Analysis page for CPU demand

•Verify VDI workload property for memory subscription

•Review the Hardware page to determine if the cluster has sufficient RAM

D.

•Review Analysis Page for memory use pattern

•Alert with VDI workload demand

•Analyze current and future workload in the Capacity Runaway tab for sufficient resources

In a Nutanix cluster, a Protection Domain contains 50 entities that are replicated to a remote Single Node Replication Target.

The current schedule configuration is as follows:

• Repeat every 6 hours

• Local Retention Policy 1

• Remote Retention Policy 8

• Starting time 12 am

At 8 am on Monday, the administrator discovers that a protected VM is corrupted. The latest good state was Sunday 2 pm. The administrator needs to maintain current protection.

Which strategy should the administrator use to meet these requirements?

A.

From the Remote site, activate the Protection Domain, then re-protect the entity.

B.

From the Remote site, restore the VM from the local snapshot by selecting the correct snapshot

C.

From the local site, retrieve the correct remote snapshot, then restore the VM locally.

D.

From the local site, restore the VM from the local snapshot by selecting the correct snapshot.

An administrator is performing a set of routine checks and notes that Prism Central is running with 4 vCPUs and 21 GB RAM. The organizations environment is based on two Nutanix clusters with 170 VMs plus a Legacy vSphere infrastructure. No manual changes have been done on Prism Central VM.

Which configuration justifies the current Prism Central configuration?

A.

Nutanix Move is running on Prism Central to import VMs from the Legacy Cluster.

B.

Prism Central was installed for Large Deployment environments.

C.

Prism Central is running on the legacy duster and requires more RAM.

D.

Nutanix Leap and Nutanix Flow have been enabled on Prism Central