Free Practice Questions for NICET ITFAS-Level-1 Exam

DACTs must attempt communication within a certain number of tries. If all attempts fail, the panel must initiate atrouble condition.

NFPA 72 (2022), Section 26.6.4.4.4.2.1:

“A maximum of 10 attempts on one line and 2 attempts on the other line shall be permitted before a trouble signal is indicated.”

That totals12 attemptsbefore declaring communication failure.

This is a documentation requirement, and it’s found inChapter 14of NFPA 72, which deals withInspection, Testing, and Maintenance.

NFPA 72 (2022), Section 14.6.3.1:

"Records shall be retained for a period of one year after the next test and until the next test is performed. Records shall be made available to the authority having jurisdiction upon request."

Section14.6.3lays out theformat, retention, and content requirementsfor inspection, testing, and maintenance records.

Correct answer: D. 14.6.3

Tip: For questions involvingrecordkeeping, head straight toChapter 14, especially section14.6.

===========

NFPA 72 specifies a strict timeframe for the automatic switchover tosecondary powerafter loss of primary power.

NFPA 72 (2022), Section 10.6.7.1.2:

“Transfer to secondary power shall occur within 30 seconds after loss of primary power.”

This ensures uninterrupted monitoring and alarm functions during outages.

Correct answer: B. 30

===========

Elevator recall typically generates analarm signal, but under specific circumstances, theAHJ may approve the use of a supervisory signalinstead.

NFPA 72 (2022), Section 21.3.3.3 (Exception):

“Where permitted by the AHJ, activation of elevator recall initiating devices shall be permitted to result in a supervisory signal.”

This allows flexibilitywith AHJ approval, not at the discretion of designers or owners.

Correct answer: A. Where approved by the authority having jurisdiction

===========

Secondary power supplies must meet minimum performance durations to ensure alarm operation when primary power fails. According to NFPA 72, the system must be able to:

NFPA 72 (2022), Section 10.6.7.2.1.1:

“The secondary power supply shall have sufficient capacity to operate the system under quiescent load for a minimum of 24 hours, followed by 5 minutes of alarm (for emergency voice/alarm communication systems, 15 minutes of alarm), unless otherwise permitted by 10.6.7.2.1.2.”

However, thedefault minimumfor most systems (non-voice) is:

24 hours in normal (quiescent) mode

Followed by 5 minutes of full alarm operation

Correct answer: A. 5 minutes

===========

Control valve supervisory switches must be tested to verify that they send a signal when the valve position changes (e.g., valve is closed). NFPA 72 requires this to be doneannually.

NFPA 72 (2022), Table 14.4.3.2 — Testing Frequencies:

Control valve supervisory switch:

Frequency:Annually

Method:Operate valve control; verify signal annunciation.

Correct answer: D. Annually

===========

Ground-fault monitoring circuits are required on many fire alarm systems to detect when a wire has unintentionally contacted a grounded surface. During testing, the inspectorintentionally introduces a groundto verify that the panel can detect it.

NFPA 72 (2022), Section 10.17.1:

"Ground-fault conditions shall be annunciated in accordance with the requirements of this Code."

Testing method:

Thestandard functional testis tointentionally ground a circuit(typically using a known resistor) and verify the control panel indicates aground-fault supervisory signal.

Correct answer: D. Verify the ground-fault indication when circuits are grounded

===========

NFPA 72 requiresaudible and visible indicationsoftrouble conditionsto be presentat the fire alarm control unitand ata constantly attended location, such as anemergency command center.

NFPA 72 (2022), Section 10.14.2:

“Trouble signals shall be indicated visually and audibly at the protected premises at the fire alarm control unit and at a location where personnel are present 24 hours a day.”

In many buildings, that location is anemergency command center.

Correct answer: Emergency command center, Fire alarm control unit

===========

Animpairmentoccurs when part of the life safety system isdisabled or rendered ineffective. Aclosed sprinkler valvedirectly disables part of the fire suppression system, which meets the definition of an impairment.

NFPA 72 (2022), Section 3.3.149 — Impairment:

“A condition where a fire protection or life safety system or portion thereof is out of service.”

Smoke detector placement issues may be acode violationbut not a systemimpairment.Intelligible audibilityis a positive attribute, not a problem.

Correct answer: A. Closed sprinkler valve

===========

When a system monitors sprinklerwaterflow(alarm) andvalve tamper switches(supervisory), the system must send the following to the supervising station:

Alarm signals(from flow)

Trouble signals(e.g., open circuits)

Supervisory signals(e.g., valve partially closed)

NFPA 72 (2022), Section 26.2.2.1:

"A fire alarm system connected to a supervising station shall transmit alarm, trouble, and supervisory signals..."

There isno requirementfor phone line failure or primary power loss to be transmitted unless required by local code.

Correct answer: B. Alarm, trouble, and supervisory

===========