What is the insertion loss guideline for a multimode mechanical splice?
What is the connector of choice for Series 59, Series 6, and Series 11 applications?
Which of the following is true about screened twisted pair cable assemblies?
Which of the following is NOT a design consideration for broadband video distribution?
You are extending 1000 MHz video service from your existing headend to a new equipment room (ER). Your existing incoming video signal is plus (+) 15 dBmV. You have three two-way splitters with a total of minus (-) 15 dB. You are adding 122 m (400 ft) of series 11 (RG 11) cable with a minus (-) 18 dB with eight single end F-connectors with a total of minus (-) 1.2 dB. From the selections below, what is the MINIMUM gain amplifier required in the headend room?
The information technology system (ITS) designer should design conduits entering a building from below grade point to extend ________ above finished floor (AFF).
An outside plant (OSP) cable must be placed under a pipeline with two side by side pipe runs. The distance between the outside pipes is 6 m (20 ft). What is the length of the conduit required to facilitate the pipeline crossing?
To reduce the chance of an accidental dig-up, plastic warning tape should be placed a MINIMUM of _________ below grade, but high enough above cables to allow detection before cables are damaged.
The MOST common medium used to provide service to the access point (AP) is ________ cable.
Vertical conduit masts (with approved service heads) are limited to drop-wire attachments of up to ________ lines.
